Description
Overview
This 2027 Peterbilt Model 567 conventional day cab is a tri-axle dump truck for construction work. It is spec’d for construction materials and on/off-highway construction dump service, with a 16' steel end dump body. The powertrain is set for a typical operating speed of 65 MPH and tuned for balance in service with frequent start and stop cycles. It is rated for a maximum grade of 6 percent.
Engine & Drivetrain
Power comes from a Cummins X15 Production Series engine with 2024 emissions. It is rated at 450 HP at 1,900 RPM, governed at 2,000 RPM, and makes 1,650 lb-ft of torque at 950 RPM. The engine is EPA emission compliant and EPA idling compliant. It runs on EMUX electronics architecture and has an engine idle shutdown timer with an ambient temperature overrule. A Jacobs compression brake is fitted, with the engine brake controls on the right-hand column. The engine bay has a remote PTO/throttle provision with a 12-pin connector, and the PTO maximum engine speed is set at 1,400 RPM. Other engine equipment includes a PACCAR Premium starter, a PACCAR 160-amp brushed alternator, and three PACCAR Premium 12V dual-purpose batteries totaling 2,190 CCA. It also has a battery jumper terminal under the hood, a Kissling 300A cab power disconnect switch, and a low-voltage disconnect system. An immersion-type 110–120V block heater, a 2-speed fan clutch for frequent start/stops, an 18.7 CFM aspirated air compressor, and a high-efficiency cooling system round out the package. Fuel filtration uses a PACCAR fuel/water separator with fuel heat for the fuel filter and a fuel cooler. Air intake is a single firewall-mounted air cleaner. Exhaust is a single right-hand system with a single-module DPF/SCR mounted under the cab on the right-hand side. It exits through a 24", 5" diameter chrome standpipe with clear coat and a curved tip.
The transmission is an Allison 4500 RDS-P Gen 6 Rugged Duty Series automatic in a 6-speed configuration. It has a TC-531 torque converter and a dash-mounted push-button shifter. It is set up with Allison primary shift schedule 2 and Allison HS/RDS package 223. Auto neutral activates with the parking brake, and Allison Neutral at Stop is enabled. The radio mutes automatically when the transmission is in reverse. The driveline is an RPL25 SD with one midship bearing and an RPL20 interaxle driveline. A dash-mounted, single-acting electric-over-hydraulic PTO control is included. A SmartLinq remote diagnostics 5-year subscription is listed for this Cummins engine.
Chassis & Axles
The chassis rides on 10-5/8" steel frame rails with a 5/16" rail thickness and a full steel inner liner. It has heavy-duty iron front spring brackets front and rear, aluminum frame rail crossmembers, and a square end of frame with a steel crossmember. Wheelbase is 217", with 142.9" cab-to-axle, 206.9" cab-to-end-of-frame, and 74.1" front-axle-to-back-of-cab. GVWR is 78,190 lbs and GCW is 82,000 lbs. Engineering-assigned axle ratings are 19,840 lbs front, 12,350 lbs on the pusher, and 23,000 lbs on each drive axle.
The front axle is a Meritor MFS20 rated at 20,000 lbs with a 3.5" drop and a Meritor wide track. Steering is TRW TAS85 dual-gear power steering with a frame-mounted reservoir and cooler, and the front spring pins are greasable. The rear axles are a Meritor RT46-164E tandem rated at 46,000 lbs, with a 5/8" wall and a 4.10 ratio. The tandem has a driver-controlled differential lock with speed interlock and a separate dash control for full-lock traction. A Hendrickson EXS13 self-steering pusher axle rated 13.5K lbs, with its own air tank, sits 52" from the centerline of the forward drive axle. Its lift axle regulator is mounted on the crossmember, with the switch and gauge in the dash. The axle stows higher when lifted to maximize ground clearance. All axles use synthetic lubricant.
Air disc brakes are fitted on the steer axle and the tandem drive axles. The steer axle has PHP10 iron Preset+ hubs, and the drive axles have PHP10 aluminum Preset+ hubs. The self-steering pusher has PHP10 iron Preset+ hubs with cast drums. Safety systems include Bendix ESP Electronic Stability Program with ATC (spec’d for end dump/roll-off), a 6S6M anti-lock braking system, an ABS off-road switch, and a switch to deactivate traction control. A tire pressure monitoring system, an SBM valve, and a pneumatic park brake are also included. Air equipment includes a heated Bendix AD-HF EP air dryer with a coalescing filter and extended purge, steel painted air tanks with pull cords on all tanks, and nylon chassis hose. There is a self-returning dash-mounted brake hand valve, 5' back-of-cab body connections, and air/electric connections in the end-of-frame crossmember.
Suspension
The rear suspension is a Hendrickson HMX EX 460 HaulMaax rated at 46,000 lbs, with a 54" axle spread, a 70K creep rating, and dedicated shock absorbers. Up front are taper leaf springs rated at 20,000 lbs with Tenneco shocks and 80 mm spacer blocks. Cab air suspension is included.
Cab & Interior
The day cab is a 121" BBC aluminum cab with a Metton hood, a stainless steel crown and grille, and hood tilt assist. Inside is a Prestige interior in Sterling Gray with a thermal insulation package. The driver gets a Peterbilt high-back, air-ride vinyl seat in black with left and right armrests. The passenger seat is a non-adjustable, non-air-ride high-back vinyl seat with a left armrest and a toolbox underneath. The steering wheel has multi-function audio and cruise controls on a tilt/telescoping column. Displays include a 15" digital instrument cluster and a 7" infotainment display with Apple CarPlay, played through a four-speaker midlevel package. The cluster shows engine oil temperature, transmission oil temperature, air filter restriction, brake application air pressure, trailer reservoir air pressure, turbo boost, engine percent torque, engine and PTO hourmeters, and pusher axle pressure. Comfort and convenience features include power door locks and windows, a combination fresh air heater and air conditioner, intermittent electric wipers, and vanity mirrors on the sunvisors. There is also a rear wall map pocket, two additional dash switches, auto-reset circuit protection, a CB antenna on the left side of the roof, and global telematics hardware. Visibility comes from a one-piece curved windshield, a fixed one-piece rear cab window, and motorized, heated Peterbilt aero mirrors with integrated convex lenses and bright housings. Round hood mirrors on stainless tube arms and a look-down mirror over the passenger door add coverage. Safety equipment includes high-visibility yellow interior grab handles, a textured NFPA-compliant exterior grab handle, an anti-theft system, a 107 dB backup alarm, a fire extinguisher, and a triangle reflector kit.
On the exterior, the cab has a stainless steel outside sunvisor, 2.25" fender lips, projector headlights with fender-mounted turn signals, five aero LED marker lights, and two Peterbilt fog lights recessed in the bumper behind a stainless gravel guard. The polished aluminum bumper is swept back with a toe step cutout. Other features include a removable bugscreen behind the grille, an air horn under the cab, square stop/turn/tail/backup lights, and a right-hand aluminum non-slip aftertreatment cab entry step. Paint is a two-stage Axalta finish in white on the cab, hood, fenders, and roof, with a black frame.
Body & Equipment
The truck carries a new 16' steel Model #4 dump body. The floor is 1/4" A36 steel. Main longitudinal sills are 7x9.8 U-channels reinforced with weld-on gussets, and the 4" x 1.5" crossmembers sit on 12" centers. The smooth sides stand 54" high in 3/16" A36 steel, with a 3.5" x 3.5" x 3/16" top side. The 56" tailgate is 1/4" smooth plate with an outer frame only, hung on weld-on rear hinges between slanted rear vertical columns. The body has a centered narrow cab shield with a 26" projection and a 3/16" heavy-duty apron, 10" in size. Standard 2" LED lights are mounted on the front and rear vertical columns. The hydraulics include an electric PTO, a DM air-shift hydraulic pump, a hydraulic reservoir, a cylinder base, and a Custom Hoists Model 74-4401-135 hydraulic cylinder. A new hitch plate kit adds a pintle hook, safety D-rings, a seven-way electrical plug, and glad hands.
The chassis carries a 26" aluminum 90-gallon fuel tank under the cab on the left-hand side. The tank is polished, with a polished non-slip step and polished straps. The DEF tank is a small heavy-duty 14-gallon unit with a polished stainless steel cover, mounted on the right-hand side back of cab. The polished aluminum space-saver battery box is on the left-hand side back of cab, with access from the side.
Tires & Wheels
The steer axle runs 20-ply 385/65R22.5 HAC3 tires on Alcoa 22.5x12.25 high-polish aluminum wheels. The tandem drive axles run eight 16-ply 11R22.5 HSC3 tires on 22.5x8.25 wheels: Accuride Steel Armor steel inner wheels with Alcoa high-polish aluminum outer wheels. The self-steering pusher runs two 14-ply 11R22.5 HSR3 tires on Alcoa 22.5x8.25 high-polish aluminum severe-service wheels. All tires include TPMS sensors. The outer surfaces have a mirror polish and a Dura-Bright finish on the steer, drive, and pusher positions, and the tandem axle has wheel guards between the wheels. The rear mudflaps and hangers are omitted from the chassis.
Warranty & Protection
This new truck comes with Peterbilt Class 8 Standard Coverage of 1 year/100,000 miles (160,000 km). It also carries a base emissions warranty of 5 years/100,000 miles.Specifications
Year2027
ManufacturerPETERBILT
Model567
Mileage11 mi
ConditionNew
Stock NumberVD 822187
Horsepower450 HP
Engine ManufacturerCUMMINS
Engine ModelX15
Fuel TypeDiesel
TransmissionAutomatic
Transmission ManufacturerALLISON
Transmission TypeAllison RDS
SuspensionHendrickson HMX460
Number of Rear AxlesTri
Gross Vehicle Weight RatingClass 8: 33,001 pounds or greater
Front Axle Weight20,000 lb
Rear Axle Weight46,000 lb
Wheelbase217 in
Drive SideLeft Hand Drive
CompositionSteel
Dump TypeEnd
TarpYes
ColorWHITE
CabStandard Cab
Cab StyleConventional
Year2027|
ManufacturerPETERBILT|
Model567|
Mileage11 mi|
ConditionNew|
Stock NumberVD 822187|
Horsepower450 HP|
Engine ManufacturerCUMMINS|
Engine ModelX15|
Fuel TypeDiesel|
TransmissionAutomatic|
Transmission ManufacturerALLISON|
Transmission TypeAllison RDS|
SuspensionHendrickson HMX460|
Number of Rear AxlesTri|
Gross Vehicle Weight RatingClass 8: 33,001 pounds or greater|
Front Axle Weight20,000 lb|
Rear Axle Weight46,000 lb|
Wheelbase217 in|
Drive SideLeft Hand Drive|
CompositionSteel|
Dump TypeEnd|
TarpYes|
ColorWHITE|
CabStandard Cab|
Cab StyleConventional|