2027 PETERBILT 567

    $259,500 
    Machine Location:2441 S State Road 7Fort Lauderdale, Florida 33317

    Seller Information

    View Seller Information

    THE PETERBILT STORE - FORT LAUDERDALE

    Contact:FORT LAUDERDALE - TRUCK SALES

    Phone:(954) 425-9145

    Fort Lauderdale, Florida 33317

    (954) 425-9145

    Hide Thumbnails

    Description

    Overview This new 2027 Peterbilt Model 567 Conventional day cab is spec’d as a construction dump truck for on/off-highway work hauling construction materials. It has a 235" wheelbase, 144.9" cab-to-axle and 204.9" cab-to-end-of-frame. Engineering ratings are a 79,500 lb GVWR and an 80,000 lb GCW. Gross axle weight ratings are 20,000 lbs front, 13,500 lbs first intermediate, 23,000 lbs second intermediate and 23,000 lbs rear. An Air-Flo 16.5' Hardox steel dump body and a Hendrickson self-steering pusher axle are installed, so this new Peterbilt dump truck is ready for aggregate, asphalt and jobsite hauling. Engine & Drivetrain Power comes from a 2026 model year PACCAR MX-13 Performance engine, built to 2024 series emissions. It is rated at 510 HP at 1,600 RPM with 1,850 lb-ft of torque at 1,000 RPM and governed at 2,200 RPM. The engine is CARB emission compliant and CARB idling compliant. Its EMUX electronics architecture is programmed for a typical operating speed of 62 MPH, a 64 MPH cruise control maximum and a 68 MPH maximum accelerator pedal vehicle speed. The engine idle shutdown timer is enabled with a 5-minute parked idle time. Engine monitoring protection is set to derate, and the powertrain is optimized for balance in service with frequent start and stop cycles. A PACCAR compression brake has controls on the right-hand column, and the MX retarder stays active in cruise control. Other engine equipment includes a PACCAR 160 amp brushed alternator and a PACCAR premium starter. Three PACCAR premium 12V dual-purpose batteries supply 2,190 CCA, with a battery jumper terminal under the hood on the LH frame rail. The cab and sleeper power disconnect switch (Kissling 300A) is mounted on the battery box, and a low voltage disconnect system is included. The rest of the engine package is a 110–120V immersion-type block heater, a 2-speed fan clutch for frequent start/stops, a WABCO 25.9 CFM air compressor and a PACCAR fuel/water separator with an extended service interval. It also has a high efficiency cooling system, a PACCAR MX engine fuel cooler, dual self-cleaning pre-cleaners under the hood and a firewall-mounted air cleaner. Exhaust is a single RH system with a single-module DPF/SCR under the cab. It exits through a 7" chrome-plated steel standpipe, 24" tall with clear coat and a curved tip. Power goes through an Allison 4500 RDS-P Gen 6 Rugged Duty Series transmission in a 6-speed configuration. It has a TC-571 torque converter, primary shift schedule 1, package 223 and a dash-mounted push-button shifter. Allison Neutral at Stop is included, and auto neutral engages with the parking brake. The driveline is an SPL170 HD-XL with one midship bearing plus an SPL170 XL interaxle driveline. PTO operation runs through a dash-mounted single-acting electric-over-hydraulic PTO control with cab-station PTO mode. A 12-pin remote PTO/throttle provision is in the engine bay. Chassis & Axles The frame uses 10-3/4" steel rails with 3/8" rail thickness and a full steel inner liner. It has HD iron front spring brackets, aluminum crossmembers and a square end of frame with a steel crossmember. Up front, a Meritor MFS20 20,000 lb front axle with a 3.5" drop and wide track runs with Sheppard HD94 dual-gear power steering. The frame-mounted power steering reservoir has a cooler. The front axle has PHP10 iron Preset+ hubs and air disc brakes. At the rear, a Meritor RT46-160 46,000 lb tandem uses a 4.30 ratio. It has a tandem diff lock with speed interlock, plus a separate dash control for full-lock traction. Rear brakes are Bendix air cam 16.5x7 drums, upgraded to X30 brake drums. They have rear brake camshaft reinforcement, gusseted cam brackets, dust shields and upsized parking brakes. The drive axles also have a lube pump and PHP10 aluminum Preset+ hubs. A Hendrickson EXS13 13,500 lb self-steering pusher axle sits 54" from the centerline of the forward drive axle. It has PHP10 iron Preset+ hubs with cast drums. Its regulator is mounted on a crossmember, with a switch and gauge in the dash, and the axle stows higher when lifted to maximize ground clearance. Safety systems include the Bendix ESP Electronic Stability Program with ATC for end dump applications, 6S6M ABS, an ATC deactivation switch and tire pressure monitoring. Synthetic lubricant is used in all axles. The air system has a Bendix AD-HF EP air dryer with heater, coalescing filter and extended purge. It also has painted aluminum air tanks with pull cords, nylon chassis hose, a self-returning dash-mounted brake hand valve and 5' BOC body connections. Suspension The rear suspension is a Hendrickson HMX EX 460 HaulMaax rated at 46,000 lbs, with 54" axle spacing and a 70K creep rating. The front suspension uses 20,000 lb taper leaf springs with Tenneco steer axle shocks, greasable spring pins and 80 mm spring spacer blocks. Cab & Interior The VOC 121" BBC aluminum day cab has a Metton hood, a stainless steel crown and grille, and tilt assist. Inside is a Prestige interior in Sterling Gray with a thermal insulation package and cab air suspension. The driver gets a Peterbilt LX premium-level high-back air ride seat in black fabric/vinyl with LH and RH armrests. The passenger has a Peterbilt ST high-back non-adjustable vinyl seat with a LH armrest, a toolbox underneath and tow hook holders. The steering column tilts and telescopes. The leather-wrapped premium steering wheel has multi-function audio and cruise controls. A 15" digital instrument cluster shows a long list of readouts: engine oil, transmission oil and both drive axle oil temperatures turbo boost and engine percent torque engine and engine PTO hourmeters air filter restriction brake application and trailer reservoir air pressure pusher axle pressure A 7" infotainment display with Apple CarPlay plays through a 4-speaker midlevel package, and the radio mutes when the transmission is in reverse. There is a factory CB antenna mount on the LH cowl and global telematics hardware. Other cab features are power door locks and windows, a combination fresh air heater/AC and a one-piece curved windshield. The fixed one-piece rear window has dark tint. Outside you’ll find a stainless steel sunvisor and Peterbilt aero mirrors in a bright finish, motorized and heated with integrated convex. A look-down mirror sits over the passenger door, with round hood mirrors on both sides. The cab also has an exterior cab entry grab handle, an under-cab air horn, a removable bugscreen and intermittent electric wipers. Lighting includes projector headlights with fender-mounted turn signals, daytime running lights, five aero LED marker lights and two flush-mounted load lights. The fire extinguisher is mounted outboard of the driver seat, and a triangle reflector kit and a variable 87–112 dB backup alarm are included. The cab, hood, fenders and roof are white Axalta two-stage paint, and the frame is black. Body & Equipment The body is an Air-Flo 16.5' steel dump body, model AFT-16.5-ST-HD, with 54" sides, a 60" tailgate and a 99" overall width. The sides are 3/16" Hardox AR 450, smooth with no gussets, with a 4" top rail and a dirt-shedding bottom rail. They are topped by 17.5–20' wood side boards painted black. The floor is 1/4" Hardox AR 450 over 3/16" formed high-strength steel longsills, with no crossmembers. The 2-panel tailgate is 1/4" Hardox AR 450 with an air-operated latch, high-lift operation and a 10" bolt-on spreader apron. The body raises on a single-acting front trunnion telescopic hoist with a rear hinge. It is fed by a slim front-mount steel doghouse reservoir and a hot shift PTO with dump pump for the Allison automatic transmission, using the factory OEM PTO switch. Body controls are air-operated on an aluminum tower, and two body props are included. A 10 GA cabshield covers the cab; it is 24" long with a 6" face and 70" wide, narrowed on both sides. A front left side ladder has three inside steps and a shovel holder. Other body equipment is a low-mount electric arm asphalt tarp, a 50-ton pintle hook and plate with a trailer plug and D-rings, and six strobes (two rear corner posts, two front cab shield, two cab shield sides). The body also has LED stop/turn/tail, marker and clearance lights, a backup alarm, rear rubber mud flaps and standard front aluminum splash guards. It is grit-blast prepped, epoxy primed and painted Air-Flo Black. The chassis also carries a polished deep tapered aluminum bumper with a toe step cutout and 2.25" fender lips. A 110-gallon 26" polished aluminum fuel tank is mounted LH under cab with a polished non-slip step and polished tank straps. The 24-gallon DEF tank sits LH back of cab with a polished stainless steel cover. A polished aluminum space-saver battery box is mounted RH back of cab with side access, and a non-slip aftertreatment cab entry step is RH under cab. Tires & Wheels Steer tires are 20-ply 315/80R22.5 HSC3 on Alcoa 22.5x9.00 high polish aluminum wheels. The eight rear tires are 16-ply 11R22.5 HSC3 on Alcoa 22.5x8.25 high polish aluminum severe service wheels. The pusher axle runs two 16-ply 11R24.5 HSR3 tires on Alcoa 24.5x8.25 high polish aluminum wheels. Every wheel position has a mirror-polished, Dura-Bright finished outer surface, and the tires include TPMS sensors. Wheel guards are installed on the tandem and pusher axles. Warranty & Protection This truck carries Peterbilt Class 8 standard coverage for 1 year/100,000 miles (160,000 km). The PACCAR MX engine has standard coverage for 2 years/250,000 miles (400,000 km)/6,250 hours. Base emissions warranty coverage is 5 years/100,000 miles. The PACCAR MX engine also comes with a 5-year SmartLINQ remote diagnostics/OTA subscription.

    Specifications

    Year2027
    ManufacturerPETERBILT
    Model567
    Mileage11 mi
    ConditionNew
    Stock NumberVD 822588
    Horsepower510 HP
    Engine ManufacturerPACCAR
    Engine ModelMX-13
    Fuel TypeDiesel
    TransmissionAutomatic
    Transmission ManufacturerALLISON
    Transmission TypeAllison RDS
    SuspensionHendrickson HMX460
    Number of Rear AxlesTri
    Gross Vehicle Weight RatingClass 8: 33,001 pounds or greater
    Front Axle Weight20,000 lb
    Rear Axle Weight46,000 lb
    Wheelbase235 in
    Drive SideLeft Hand Drive
    CompositionSteel
    Dump TypeEnd
    Body ManufacturerAIR-FLO
    TarpYes
    ColorWHITE
    CabStandard Cab
    Cab StyleConventional
    Year2027|
    ManufacturerPETERBILT|
    Model567|
    Mileage11 mi|
    ConditionNew|
    Stock NumberVD 822588|
    Horsepower510 HP|
    Engine ManufacturerPACCAR|
    Engine ModelMX-13|
    Fuel TypeDiesel|
    TransmissionAutomatic|
    Transmission ManufacturerALLISON|
    Transmission TypeAllison RDS|
    SuspensionHendrickson HMX460|
    Number of Rear AxlesTri|
    Gross Vehicle Weight RatingClass 8: 33,001 pounds or greater|
    Front Axle Weight20,000 lb|
    Rear Axle Weight46,000 lb|
    Wheelbase235 in|
    Drive SideLeft Hand Drive|
    CompositionSteel|
    Dump TypeEnd|
    Body ManufacturerAIR-FLO|
    TarpYes|
    ColorWHITE|
    CabStandard Cab|
    Cab StyleConventional|
    Show As Paragraph

    Your current browser cannot run our content, please make sure your browser is fully updated or try one of the browsers below.

    Your browser is not supported

    Microsoft Edge

    Google Chrome

    Mozilla Firefox